SKU:
-
SHARE:
The FastBreak Sander allows you to uniformly break the edge on sharp melamine material in just one pass. The FastBreak dramatically increases the speed and efficiency in which you ease and break sharp and chipped edges. The FastBreak and FastBreak XL use the same sandpaper refills. The fastbreak uses 1 sheet at a time while the xl uses 2 sheets.
FastBreak Overview
Fastedge Basics
Wood Fastedge Edgebanding Basics
FastEdge Over Edge Banding
WoodShop Addict Review
Geek Group Review
español
FastBreak
Sands from 1/4" to 1-1/8"
FastBreak XL
Sands from 3/4" to 2-3/8"
80 Grit & 180 Grit Sandpaper size:
1-3/4" wide & 5-7/8" Height
So easy!
This FastCap product works exactly as advertised. It has to be at least 10 times faster than filing edge banding by hand. Works equally well on melamine, plastic and veneer edge banding. After using up the included paper (which is actually emery cloth) I found that 2 pieces of PSA put back to back slide perfectly into the slots. Then I can just flip the paper to the other side when one side wears out. This is a good one - thank you FastCap!
finger saver
I have used this on solid wood edges and plywood. Works great to break over the edges on both. Used it on some melamine banding I put on and worked great. I would buy the replacement sheets from Fastcap, the tolerances are real tight. Don't know if you could cut a sheet of sandpaper to fit or not. One added thing is if you sand up sliver of wood from you edge, it goes into the body of the sander and NOT in your finger.
Check out our review!